30 Inch by 6 Inch H-Shaped Fire-On-Water Submersible Manifold

Watery flame (and two-and-a-half feet of it)!

Dual inline 30" linear burners deliver dancing flames over the surface of the water!
30 Inch by 6 Inch H-Shaped Fire-On-Water Submersible Manifold This submersible burner requires an electronic ignition system to operate. Fire on water is the perfect addition to your fountain, reflecting pool, or water basin.
* Required Fields
Availab.: Available
Code: LP-HB-30" NG
Brand: CJs Custom Shop
Availab.: Available
Code: LP-HB-30" LP
Brand: CJs Custom Shop
$1,240.00
$1,240.00
Availab.: Available
Code: SUBEIS-NG
Brand: CJs Custom Shop
Availab.: Available
Code: SUBEIS-LP
Brand: CJs Custom Shop
Availab.: Available
Code: AFOW-NG
Brand: CJs Custom Shop
Availab.: Available
Code: AFOW-LP
Brand: CJs Custom Shop
$1,400.00
$1,400.00
$1,400.00
$1,400.00
Availab.: Available
Code: NO-AFOW-PILOT-WIRE
Availab.: Available
Code: Option-Length-01-Foot
Availab.: Available
Code: Option-Length-02-Foot
Availab.: Available
Code: Option-Length-03-Foot
Availab.: Available
Code: Option-Length-04-Foot
Availab.: Available
Code: Option-Length-05-Foot
Availab.: Available
Code: Option-Length-06-Foot
Availab.: Available
Code: Option-Length-07-Foot
Availab.: Available
Code: Option-Length-08-Foot
Availab.: Available
Code: Option-Length-09-Foot
Availab.: Available
Code: Option-Length-10-Foot
Availab.: Available
Code: Option-Length-11-Foot
Availab.: Available
Code: Option-Length-12-Foot
Availab.: Available
Code: Option-Length-13-Foot
Availab.: Available
Code: Option-Length-14-Foot
Availab.: Available
Code: Option-Length-15-Foot
Availab.: Available
Code: Option-Length-16-Foot
Availab.: Available
Code: Option-Length-17-Foot
Availab.: Available
Code: Option-Length-18-Foot
Availab.: Available
Code: Option-Length-19-Foot
Availab.: Available
Code: Option-Length-20-Foot
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
$0.00
Price as configured:
Qty:     - OR -   Add to Wish List
Add to Compare
Get 6 months to pay on purchases of $99 or more with PayPal credit!

Well over two feet of a thick wall of flame, from the unlikeliest of places! This manifold rests under the water, producing bubbles of gas from its dual inline 30" burners. As the bubbles break the surface of the pool, an electrically-ignited pilot light causes the escaping gas to burst into a constant flames that look like they're coming directly out of the liquid.

It's designed for reliability, so water won't enter the gas line: Each unit comes with a check valve that prevents backwash from getting into the pipe -- it only opens when the gas or propane fuel is turned on so that the pressure can keep the line clear.

The whole thing is powered by an electronic ignition system that controls the flow of fuel to the components. Just connect to the fuel line and a 24 volt AC power source (like a pool timer, or a 110~120 volt AC home source with a 24 volt transformer, not included), and as soon as it gets power it will turn on the gas and light it automatically. Even if the wind blows it out, the on-board sensor will detect the flame and try to light it again. If the gas is turned off or the power goes out, the system will power down until it has access to both fuel sources.

There are two types of electronic ignition for you to choose from: A SUBmersible Electronic Ignition System (SUBEIS) that mounts right to the manifold and sets in the water, and an Automated Fire On Water (AFOW) ignition that sets outside of the feature up to twenty feet (20') away for easier access and maintenance. 

It uses your choice of natural gas or liquid propane fuel.

Benefits and features:

  • Two (x2) 30" long burners mounted 6" apart for a broad linear flame
  • Stainless steel design is rated for both freshwater and saltwater environments
  • Comes in your choice of propane or gas fuel
  • Only requires 0.5 PSI to operate (at recommended depth)
  • Electronic ignition system controls pilot light and gas flow
  • AFOW system comes with up to 20' of line for the installation
  • Shuts off gas if the power goes out
  • Re-lights the fire if the wind blows it out 

-icon-usaflag.pngProudly made in the USA

How does it work?

When the gas is turned on, the ring will release jets of gas.

Once the electronic ignition system is turned on (SUBEIS shown), the gas will flow through the manifold, out of the water, and into the air.

After a few moments, the electronic ignition will turn on, igniting the gas.

After a few moments, the pilot light will turn on, igniting the gas that is escaping over the water.

Once the flames are lit, they will stay lit as long as the gas continues to feed through burner.

The result is that the flame will hover over the water, stopping at the waterline, keeping the manifold and electronics protected from the heat.

What ignition system should I choose?

There are two different ignition systems that you can choose to start the gas on your submersible manifold. While the two systems operate identically for the most part, they install quite differently.

The SUBmersible Electronic Ignition System (SUBEIS) has a sealed electronic valve system that is designed to be submerged in the water. The manifold attaches directly to the SUBEIS.

Pro:

  • Easy to install 

Con:

  • Difficult to access for maintenance 

This is a PDF file and may require additional software to view. Click to view SUBEIS installation instructions

SUBEIS

SUBEIS systems are submersible under the water

The Automated Fire On Water (AFOW) ignition system is not sealed and must be installed outside of the water feature. The pilot igniter's wire and gas line can be ordered up to 20 feet long.  

Pro:

  • Easy access for maintenance 

Con:

  • Relatively difficult installation 

This is a PDF file and may require additional software to view. Click to view AFOW installation supplement

AFOW

AFOW system's electronics sit outside of the water

How deep underwater does the manifold have to be?

It's recommended that you install it 1/2" to 2" below the surface of the water. The closer you install the manifold to the surface of the water, the better the performance you will get. 

Can I burn the manifold outside of water?

Do not run manifold without it being submersed in water! The heat could damage the check valve and electronics.

How much pressure do I need? 

These products require minimum 0.5 psi to operate. If you install the manifold deeper than recommended you may need a higher pressure line. You will need to get a high pressure regulator installed to the fire feature with a pressure regulated spring rated at 3 - 6 PSI. For natural gas installation you require a high output meter, usually supplied by your gas provider at no cost to you. For propane installation you will need a high output regulator, usually supplied by your gas provider. It has to be rated for at least 3 PSI and up.

Won't water get in when I'm not using it?

All manifolds are shipped with a check valve that prevents backwash.

What's it made out of?

The manifold is made out of 316 stainless steel, and is rated to resist saltwater and corrosion.

How do I light it?

These features require the use an AFOW or SUBEIS electronic ignition to light. These systems act as both the gas valve and the ignition, and are perfect for manifolds that are mounted in the middle of large bodies of water. ALWAYS STAND UPWIND WHEN LIGHTING ANY FIRE FEATURE!

Where can I mount it?

It is the buyer's responsibility to check local codes, restrictions and enforcement for installations. Units must be installed by a local licensed contractor. CAN NOT BE USED INDOORS!

What if I want something different -- can I take it apart and put it together differently? 

NO. The parts are configured, sealed and powder coated in a specific configuration to meet safety standards, but there's good news: Larger sizes and different shapes are available for custom order. Please contact our office at 1-888-986-1535 if you need something special.

There is a one year warranty on the stainless steel material. The replacement tips have a 3 month warranty and can be ordered at any time. With proper maintenance, the tips should last for up to 2 years, depending on the hardness of the water. The system is very durable and is built to last.

Usually ships in 5-10 Business Days.

Due to the custom nature of this product, it is not returnable.

Specifications
Material #316 Stainless Steel (manifold)
BTU 125,000 max
Fuel Type Natural gas or liquid propane
Required Pressure 0.5 PSI
Voltage 24 volts AC
Width 6"
Length 30"
There are no reviews for this product.

Write a review

Review for:


Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:

Please Enter a Captcha to Prove You Are Not a Robot

No questions added yet

For any questions about 30 Inch by 6 Inch H-Shaped Fire-On-Water Submersible Manifold please use the form below.

Name:


E-mail:



My Question:
Note: Questions are viewable by the public. Please do not include personal information such as addresses or phone numbers. HTML is not translated.


Enter the code in the box below:

Please Enter a Captcha to Prove You Are Not a Robot

Tags: outdoor, fire, water, gas
* Last updated on January 9th 2017.
* Product, parts, color, finish, or texture may vary slightly from photos.
Customer Feedback  Our customers rate us 5/5 stars.

Our loyal customers have left 56 company testimonials giving us an average of 5/5 stars for great service. Would you like to leave your own feedback, testimonial, or review? Leave My Feedback

awesome bowls
Here are some photos of the fires pots we purchased several months ago.

Anthony B rated our company service 5/5 Anthony B

Glass was broken in transit... BUT!
Glass showed up broken for some unknown reason. No questions asked these guys shipped me a new one right away! Great company. Glass fits perfectly.

Joshua Thompson rated our company service 5/5 Joshua Thompson Kernville, CA

Thanks
Hello, I got your glass today and installed it.  I was impressed in how easy it was to put the plugs in that hold the glass in place – nice engineering there. I bought the wrong color – see the attached picture (the new pane is 2nd from left) – it should be lighter.  I’ll replace it sometime before I move out; in the mean time it’s a warning to not leave the fire unattended. Thanks for the great packaging, too – I can use that cardboard in projects so it’s going to be reused.

Mike B rated our company service 5/5 Mike B

Concrete Bowls
My bowls look amazing! Could not be happier. Thank you for all the help Linda through the whole process. Very knowledgeable and prompt. Thanks again.

 rated our company service 5/5

Fire pit has small flame
When I put my fire pit glass on top of the orafice, it seems like the glass is covering the hole/ports and the fire is very sporadic which is limiting the heat from the pit. Any suggestions on what I can do?

Mart Orr rated our company service 5/5 Mart Orr Simpsonville

About CJ's Home Decor & Fireplaces LLC Thanks for Shopping CJ's!
Fire, Water, Paradise Experts Since 1999!
PH: (888) 986-1535
Fax: (814) 723-4187
Warren, PA 16365
Operators Available:
Mon-Fri 9:00-5:00 EST
Chat With an Expert!
CJs Hearth and Home © 1999 - 2017 - a Pennsylvania based company.✓ Secured: Norton | AVG | McAfee | Google
By using this site you agree to our cookie policy.
Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×